FDM-SW2 Ver 1.88Beta

*********** FDM-S2 FDM-DUO FDM-DUOr ********************

- Added the CAT support in VRX mode in the Channel 2.
- Solved a problem of tuning unlocking during recording
- In ECSS mode, the user can now drag and drop indipendently the lower and the upper side of the demodulation filter in the IF window. Avialable only in ECSS Dual (Lower + Upper), if the locking filter is set to Narrow and if the "SYMM" option in the IF window is not selected. 
- In the setup window, tab About, the displayed firmware version now is correct
- Solved a problem with the frequency display in the waterfall when the "Display Frequency At Mouse Position" option is active.

*********** FDM-S2 only *****************
- Modified the frequency calibration routine. When the "Save Offset" button is clicked, another window is opened to allow the user to modify manually the frequency offset.

*********** FDM-DUO oNLY  ********************
- Sync RX standalone with SW2-RX1 enable/disable

- Sync TX - RX (RX1) mode  enable/disable

- Added TX panels for FDM-DUO on the Channel 2

- FM transmission AND RECEPTIOn mode 

- Right click on the RX1 ... RX4 buttons to enable the TX on the selected receiver.

Added FDM-DUO Stand Alone Control PAnel
- MACRO buttons in the FDM-DUO remote hw window to execute custom sequencies of CAT commands.

By default the MACRO definitions are located in the file:
C:\Users\UT96\Documents\ELAD\FDM-SW2\FDMDUO\FdmDuoMacro.txt

Each line in the file define a macro:

"MACRO 1 Button Label";"CAT Command"...
"MACRO 2 Button Label";"CAT Command"...
"MACRO 3 Button Label";"CAT Command"...

For Example:
VHF;TT1;LP0;AN2;
"VHF" in the button label
TT1;LP0;AN2; is the squence of CAT commands

- In the FDM-DUO Stand Alone Control option windows, are displayed the FDM-DUO firmware versions, it is possible to change the default macro folder and execute an automatic frequency alignement.

FDM-DUO Advanced TX
- Added the "TUNE" button
- FM Modulation
- Modulation optimization

new CAT commands and controls

Software Version compatibility: ELAD-FDM-SW2 Ver 1.88Beta. Released April 30, 2015
RX Firmware: 1.12  *new*
TX Firmware: 1.20  *new* 
UI Firmware: 4.30  *new*	
USB Firmware: 4.08
FPGA: 2.0